Download Free Medical Intra Aortic Balloon Pump (IABP) PowerPoint Presentation

Intra Aortic Balloon Pump (IABP) PowerPoint Presentation

DOWNLOAD MEDICAL POWERPOINT PRESENTATION

About This Presentation

Description : Check out this medical presentation on Aorta, which is titled "Intra Aortic Balloon Pump (IABP)", to know about the Intra Aortic Balloon Pump and its purpose.

Tags : Aorta, Intra Aortic Balloon Pump, IABP, purpose

Published on : Jun 02, 2021 | Views : 12813 | Downloads : 84

Shareable Url :

Embed Code :

Comment

Transcript

Slide 1-

1 Intra Aortic Balloon Pump (IABP) Yan Wing Wa Department of Intensive Care Pamela Youde Nethersole Eastern Hospital
Slide 2-

2 What is an IABP? The Intra-Aortic Balloon Counterpulsation system is a volume displacement device. It should be positioned so that the tip is approximately 1 to 2 cm below the origin of the left subclavian artery and above the renal arteries. On chest x-ray the tip should be visible in the 2nd or 3rd intercostal space.
Slide 3-

3 Purpose of IABP Hemodynamic support in medical conditions Prophylactic hemodynamic support Cardiac support for hemodynamically challenged patients with mechanical defects PRIOR to correction
Slide 4-

4 Surgical Indications Post surgical myocardial dysfunction Support for weaning from cardiopulmonary bypass (CPB) Cardiac support following correction of anatomical defects Maintenance of graft patency post CABG Pulsatile flow during CPB
Slide 5-

5 Introducer needle Guide wire Vessel dilators Sheath IABP (34 or 40cc) Gas tubing 60-mL syringe Three-way stopcock Arterial pressure tubing (not in kit) IABP Kit Contents
Slide 6-

6 The IAB Should be selected according to the following chart (chart located on every box). Note: The 50cc balloons are no longer made by Datascope IAB Sizing Chart
Slide 7-

7 Percutaneous Sheath less Surgical insertion Femoral cut down Trans-thoracic Insertion Techniques
Slide 8-

8 The end of the balloon should be just distal to the takeoff of the left subclavian artery Position should be confirmed by fluoroscopy or chest x-ray Positioning
Slide 9-

9 Insertion Position On chest x-ray the tip should be visible in the 2nd or 3rd intercostal space
Slide 10-

10 Pressure Waveforms
Slide 11-

11 Desired Outcome Appropriately timed blood volume displacement (30 – 50 mL) in the aorta by the rapid shuttling of helium gas in and out of the balloon chamber, resulting in changes in inflation and deflation hemodynamics
Slide 12-

12 Inflation The goal of inflation is to increase or augment perfusion
Slide 13-

13 Inflation of IABP Results In: Increased coronary perfusion pressure Increased systemic perfusion pressure Increased O2 supply to both the coronary and peripheral tissue Increased baroreceptor response Decreased sympathetic stimulation causing decreased HR, decreased SVR, and increased LV function
Slide 14-

14 Deflation The goal of deflation is to reduce LV workload Deflation creates a "potential space" in the aorta, reducing aortic volume and pressure
Slide 15-

15 Deflation of the IABP Results In: Afterload reduction and therefore a reduction in MVO2 Reduction in peak systolic pressure, therefore a reduction in LV work Increased cardiac output Improved ejection fraction and forward flow
Slide 16-

16 How do you Know? Afterload reduction? Change in diastolic pressures Unassisted and assisted Decreased workload? Change in systolic pressures Unassisted and assisted Improved cardiac output? Increase in pulse pressures
Slide 17-

17 Review of Arterial Pressure Landmarks AVO = Aortic valve opens, beginning of systole PSP = Peak systolic pressure, 65-75% of stroke volume has been delivered DN = Dicrotic notch, signifies aortic valve closure and the beginning of diastole AEDP = Aortic end diastolic pressure
Slide 18-

18 IABP Waveform Zero baseline (on console) Balloon pressure baseline Rapid inflation Peak inflation artifact Balloon pressure plateau (IAB fully inflated) Rapid deflation Balloon deflation artifact Return to baseline (IAB fully deflated) Duration of balloon cycle
Slide 19-

19 Inflate just prior to the dicrotic notch To accomplish the goals of inflation, the balloon must be inflated at the onset of diastole The result of properly timed inflation is a pressure rise during diastole
Slide 20-

20 Review of Arterial Pressure Landmarks in 1:2 Assist Patient AEDP PSP (unassisted systole) PDP/DA (diastolic augmentation) Balloon AEDP APSP (assisted systole)
Slide 21-

21 Inflation Hemodynamics Coronary artery blood flow and pressure are increased Increased renal and cerebral blood flow Increased diastolic pressure increases perfusion to distal organs and tissues
Slide 22-

22 Inflation Hemodynamics Coronary collateral circulation is potentially increased from the increase in coronary perfusion pressure (CPP) Systemic perfusion pressure is increased
Slide 23-

23 Coronary Perfusion Pressure The pressure at which blood perfuses through the coronary circulation, mainly in diastole Blood flow to the left ventricle occurs principally during diastole and is largely determined by the driving pressure (diastolic pressure minus left ventricular diastolic pressure), the diastolic interval and the state of coronary vasodilatation
Slide 24-

24 Deflation Hemodynamics The pressure that the LV must generate (afterload) is less throughout the systolic phase Decreases myocardial O2 demands Isovolumetric contraction (IVC) phase of systole is shortened Decreases myocardial O2 demands
Slide 25-

25 Deflation Hemodynamics Reduced afterload allows the LV to empty more effectively so stroke volume (SV) is increased Enhanced forward cardiac output decreases the amount of blood shunted from left to right in cases of intraventricular septal defects and incompetent mitral valve
Slide 26-

26 Triggering It is necessary to establish a reliable trigger signal before balloon pumping can begin The computer in the IAB console needs a stimulus to cycle the pneumatic system, which inflates and deflates the balloon The trigger signal tells the computer that another cardiac cycle has begun
Slide 27-

27 Triggering In most cases it is preferable to use the R wave of the ECG as the trigger signal There are other trigger options for instances when the R wave cannot be used or is not appropriate
Slide 28-

28 Trigger Loss The console MUST see a trigger to initiate an inflate/deflate cycle If no trigger is seen when the clinician attempts to start pumping, no pumping will occur and an alarm will be sounded If the trigger is lost after pumping starts, no further pumping will occur until a trigger is re-established
Slide 29-

29 Trigger Loss If the current trigger is lost the clinician can choose an alternate, available trigger to resume pumping For example, if the ECG lead becomes disconnected the arterial pressure (AP) trigger may be selected until the ECG is re-established
Slide 30-

30 ECG Trigger Since triggering on the R wave of the ECG is preferred, it is very important to give the IABP a good quality ECG signal and lead
Slide 31-

31 Poor ECG Choices Note: changing QRS morphology may cause wandering timing Note: tall T waves may cause double triggering or may alter previously set timing points Note: wandering baseline may cause skipped trigger Note: artifact may cause inappropriate triggering
Slide 32-

32 ECG Gain In addition to selecting a lead with a QRS morphology that provides consistent, appropriate triggering, it is important to ensure the QRS complex has adequate amplitude
Slide 33-

33 Triggering on the Arterial Pressure Waveform Arterial pressure provides another signal to the IABP to determine where the cardiac cycle begins and ends It is used when the ECG has too much interference from patient movement or poor lead connection
Slide 34-

34 CPR AP trigger is the appropriate choice during CPR Once chest compressions are started an arterial pressure waveform will be generated Triggering on the AP will produce pumping in synchrony to chest compression and has been shown to assist with coronary and carotid perfusion
Slide 35-

35 TRIGGER MODES: ECG The computer analyzes the SLOPE and HEIGHT of a positively or negatively deflected QRS complex. Rejects pacer spikes on the basis of sharp rising edge. Automatically initiates ARRHYTHMIA TIMING when at least 8 out of 16 beats are detected as irregular. In most instances this is the trigger of choice.
Slide 36-

36 TRIGGER MODES: ECG In AUTOPILOT mode, if no QRS or AP trigger is found, it will trigger on the V SPIKE of an AV paced rhythm. In OPERATOR mode, the ECG trigger key can be used to toggle between triggering on the R WAVE and the V SPIKE of a V or AV paced rhythm.
Slide 37-

37 TRIGGER MODES: ARTERIAL PRESSURE (AP) The computer uses the SYSTOLIC UPSTROKE of an arterial pressure waveform as the trigger signal. A 14mmHg minimum pulse pressure is required to initially recognize the trigger. Once pumping begins the subsequent pulse pressure requirement is reduced to 7mmHg. Every 64th beat is unassisted and reassessed. This mode is available as an option for clinical situations where an ECG is unavailable or distorted. Not recommended for irregular rhythms or irregular pulse pressures.
Slide 38-

38 Gas Alarms/Balloon Pressure Waveform During a cycle of inflation/deflation, helium is rapidly moved in and out of the balloon. The environment within the balloon and the surrounding forces that affect balloon behavior all contribute to a predictable pattern of gas flow and pressure. The gas pressure characteristics are converted into a waveform that is reflective of the behavior of the gas.
Slide 39-

39 This transduced waveform tells much about the interaction of the balloon within the patient's aorta. Understanding the balloon pressure waveform is important for troubleshooting of the console as most alarms are based on the gas surveillance system.
Slide 40-

40 IABP Waveform Zero baseline (on console) Balloon pressure baseline Rapid inflation Peak inflation artifact Balloon pressure plateau (IAB fully inflated) Rapid deflation Balloon deflation artifact Return to baseline (IAB fully deflated) Duration of balloon cycle
Slide 41-

41 Normal Waveform Variations Tachycardia Bradycardia Hypertension Hypotension
Slide 42-

42 Abnormal Waveform Variation: Wide Inflation and/or Deflation Artifact Check for kinks, as they may trap gas in the IAB. If water is present in the gas tubing, remove the condensation. Pushing the helium through the water during inflation and deflation slows down gas transition. If gas transition is prolonged too much, it can create alarms.
Slide 43-

43 Abnormal Waveform Variation: Helium Loss / Gas Loss / Gas Leakage Alarms Observe for blood in the gas tubing. If even a slight amount is present, it may indicate a balloon rupture. Do not resume pumping. Notify physician immediately and prepare for IAB removal. Check connections where gas tubing connects to IAB and to pump. Secure if loose.
Slide 44-

44 Abnormal Waveform Variation: High Pressure / Kinked Line Alarm
Slide 45-

45 Reposition patient. Keep affected leg straight. Use rolled towel under hip to hyperextend hip. Apply slight traction to the catheter if kinking at the insertion site or in the artery is suspected. The distal portion of the IAB may be in the sheath if a long introducer sheath was used. Pull sheath back until IAB bladder has exited the sheath. Introducer sheath may be kinked which in turn is kinking the balloon. Suspect this particularly if placement of the sheath was difficult. Pull sheath back or rotate sheath a partial turn.
Slide 46-

46 Check placement of the balloon; it may be too high or too low. IAB may be partially wrapped if alarm occurs shortly after insertion. Take steps to facilitate unwrapping (consult IAB manufacturer). The balloon may be too large for the patient. Reduce the helium volume the balloon is inflated with. (It is recommended to not reduce the volume below 2/3 of maximum. For example, do not decrease volume in a 40cc IAB below 27cc)
Slide 47-

47 Check for intermittent obstruction of gas lumen. Check for overfill of system. This condition may occur during ascent in air transport since gas expands as you go up in altitude. Reset the alarm and restart pumping. The volume will be adjusted automatically for current barometric pressure. Abnormal Waveform Variation: High Baseline / Fill Pressure
Slide 48-

48 Complications of IABP The following patients are at the greatest risk of developing complications associated with IABP: Females, diabetics, smokers, obese patients Patients with PVD, HTN, high SVR, shock
Slide 49-

49 Complications of IABP Aortic wall dissection, rupture or local vascular injury Care as indicated Emboli: thrombus, plaque or air Care as indicated Treatment of an air embolism is as follows: 100% oxygen, intubate, Trendelenberg in left lateral decubitus position, fluid resuscitation, etc.
Slide 50-

50 Complications of IABP IABP Rupture: COFFEE GROUNDS seen in the drive line is a precursor to a rupture (make sure they are on the inside and not the outside of the tubing) NOTIFY PHYSICIAN!!!!! IF THERE IS A FLAGRANT RUPURE OF THE IABP CLAMP THE GAS LINE!!!!!
Slide 51-

51 Complications of IABP Infection Check catheter insertion site often STRICT ASEPTIC TECHNIQUE Restrict movement while IABP in place
Slide 52-

52 Complications of IABP Obstruction Malposition Too high – obstruction of left subclavian and carotids CHECK LEFT RADIAL ARTERY PULSE Too low – obstruction of renal and mesenteric arteries MONITOR URINE OUTPUT
Slide 53-

53 Complications of IABP Compromised circulation due to catheter Ischemia Routine nursing care and monitoring Compartment syndrome Rare complication seen in the LE, usually related to infection Monitor calf circumference
Slide 54-

54 Complications of IABP Hematologic ALL PATIENTS typed & crossmatched!!! Bleeding REMOVE THE DRESSING!!! PUT ON STERILE GLOVES!!! HOLD PRESSURE!!! Thrombocytopenia Routine monitoring
Slide 55-

55 Timing of weaning Patient should be stable for 24-48 hours Decreasing inotropic support Decreasing pump ratio From 1:1 to 1:2 or 1:3 Decrease augmentation Monitor patient closely If patient becomes unstable, weaning should be immediately discontinued Weaning of IABP Weaning should only be attempted on order of a physician.
Slide 56-

56 Discontinue heparin six hours prior Check platelets and coagulation factors Deflate the balloon Apply manual pressure above and below IABP insertion site Remove and alternate pressure to expel any clots Apply constant pressure to the insertion site for a minimum of 30 minutes Check distal pulses frequently IAB Removal IAB should only be pulled by a physician or the cardiac P.A.
Slide 57-

57 Thank you for your attention